1. switch Cisco catalyst C9300-48P (X86)
2. system image: Cisco IOS Software [Fuji], Catalyst L3 Switch Software (CAT9K_IOSXE), Version 16.8.1a, RELEASE SOFTWARE (fc1)
3. temperature sensor HotSpot is not recognized.
4. Alarm on temperature above 60 degree is triggered

On the switch cisco WS-C3850-12S (MIPS) processor (revision L0), Cisco IOS Software [Everest], Catalyst L3 Switch Software (CAT3K_CAA-UNIVERSALK9-M) HotSpot is correctly recognized.

Of course it is a different version of system software, but it is still IOS.

EXPECTED RESOLUTION:

In the IOS there are thresholds defined and it should be accessible via snmp.

Alerts should be related to this values and calculated due to its state.

system command

>show environement temperature on both models gives the following results:

Switch 1: SYSTEM TEMPERATURE is OK
Inlet Temperature Value: 29 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 46 Degree Celsius
Red Threshold    : 56 Degree Celsius

Hotspot Temperature Value: 55 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 105 Degree Celsius
Red Threshold    : 125 Degree Celsius
Switch 2: SYSTEM TEMPERATURE is OK
Inlet Temperature Value: 27 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 46 Degree Celsius
Red Threshold    : 56 Degree Celsius

Hotspot Temperature Value: 56 Degree Celsius
Temperature State: GREEN
Yellow Threshold : 105 Degree Celsius
Red Threshold    : 125 Degree Celsius